20-8
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D316 Log Out a User on Multiple Nodes
Step 3 In the Logout User dialog box, check Lockout before Logout if you want to lock the user out. This
prevents the user from logging in after logout based on user lockout parameters provisioned in the Policy
tab. Either a manual unlock by a Superuser only is required, or the user is locked out for the amount of
time specified in the Lockout Duration field. See the “DLP-D271 Change Node Security Policy on a
Single Node” task on page 19-74 for more information.
Step 4 Click OK.
Step 5 Click Ye s to confirm the logout.
Step 6 Return to your originating procedure (NTP).
DLP-D316 Log Out a User on Multiple Nodes
Step 1 From the View menu, chose Go to Network View.
Step 2 Click the Provisioning > Security > Active Logins tabs.
Step 3 Choose the user you want to log out.
Step 4 Click Logout.
Step 5 In the Logout User dialog box, check the nodes where you want to log out the user.
Step 6 In the Logout User dialog box, check Lockout before Logout if you want to lock the user out prior to
logout. This prevents the user from logging in after logout based on user lockout parameters provisioned
in the Policy tab. Either a manual unlock by a Superuser only is required, or the user is locked out for
the amount of time specified in the Lockout Duration field. See the “DLP-D272 Change Node Security
Policy on Multiple Nodes” task on page 19-76 for more information.
Step 7 In the Select Applicable Nodes area, deselect any nodes where you do not want to change the user’s
settings (all network nodes are selected by default).
Step 8 Click OK.
Step 9 In the User Change dialog box, click OK.
Step 10 Return to your originating procedure (NTP).
Purpose This task logs out a user from multiple nodes.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
