Cisco ONS 15454 SDH - Before You Begin

CHAPTER
8-1
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
8
Monitor Performance
This chapter explains how to enable and view performance monitoring statistics for the
Cisco ONS 15454 SDH. Performance monitoring (PM) parameters are used by service providers to
gather, store, and set thresholds and to report performance data for early detection of problems. For more
PM information, details, and definitions, refer to the Cisco ONS 15454 SDH Troubleshooting Guide.
Before You Begin
Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1. NTP-D257 Change the PM Display, page 8-2—Complete as needed to change the displayed PM
counts.
2. NTP-D195 Monitor Electrical Performance, page 8-3—Complete as needed to monitor electrical
performance.
3. NTP-D198 Monitor Ethernet Performance, page 8-4—Complete as needed to monitor Ethernet
performance.
4. NTP-D289 Create and Delete Ethernet RMON Thresholds, page 8-5—Complete as needed to
monitor Ethernet performance.
5. NTP-D254 Monitor STM-N Performance, page 8-5—Complete as needed to monitor optical
(STM-N) performance.
6. NTP-D301 Monitor FC_MR-4 Performance, page 8-6—Complete as needed to monitor FC_MR-4
performance.
7. NTP-D302 Create or Delete FC_MR-4 RMON Thresholds, page 8-6—Complete as needed to
monitor FC_MR-4 performance.
Note For additional information regarding PM parameters, refer to ITU G.826, Telcordia GR-820-CORE,
Telcordia GR-499-CORE, and Telcordia GR-253-CORE.