Cisco ONS 15454 SDH - Page 297

8-3
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 8 Monitor Performance
NTP- D195 Monitor Electrical Performance
NTP-D195 Monitor Electrical Performance
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node that you want to monitor. If you
are already logged in, continue with Step 2.
Step 2 In node view, double-click the electrical card where you want to view PM counts. The card view appears.
Step 3 Click the Performance tab (Figure 8-1).
Figure 8-1 Viewing Performance Monitoring Information
Purpose This procedure enables you to view node near-end or far-end
performance during selected time intervals on an electrical card and port
to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures Before you monitor performance, be sure you have created the
appropriate circuits and provisioned the card according to your
specifications. For more information, see Chapter 6, “Create Circuits
and Low-Order Tunnels” and Chapter 10, “Change Card Settings.”
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Retrieve or higher
Auto-refresh
drop-down list
102002
Directions
radio buttons
Performance
tab
Card View
Refresh
button
Port
drop-down list
Intervals
radio buttons
Baseline
button
Clear
button