19-72
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 19 DLPs D200 to D299
DLP- D266 Change IP Settings
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-D266 Change IP Settings
Caution Changing the node IP address, subnet mask, or IIOP listener port causes the TCC2/TCC2P cards to
reboot. If Ethernet circuits using STP originate or terminate on E-Series Ethernet cards installed in the
node, circuit traffic will be lost for several minutes while the spanning trees reconverge. Other circuits
are not affected by TCC2/TCC2P card reboots.
Step 1 In node view, click the Provisioning > Network > General tabs.
Step 2 Change any of the following:
• IP Address
• Suppress CTC IP Display
• LCD IP Setting
• Default Router
• Forward DHCP Requests To
• MAC Address
• Net/Subnet Mask Length
• TCC CORBA (IIOP) Listener Port
• Gateway Settings
See the “DLP-D249 Provision IP Settings” task on page 19-52 for detailed field descriptions.
Step 3 Click Apply.
If you changed a network field that will cause the node to reboot, the Change Network Configuration
confirmation dialog box appears. If you changed a gateway setting, a confirmation appropriate to the
gateway field appears.
Step 4 If a confirmation dialog box appears, click Yes .
If you changed an IP address, subnet mask length, or TCC CORBA (IIOP) Listener Port, both
ONS 15454 SDH TCC2/TCC2P cards will reboot, one at a time.
Purpose This task changes the IP address, subnet mask, default router, DHCP
access, firewall access, and proxy server settings for the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
