20-66
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D360 Delete a Regenerator-Section DCC Termination
Step 4 In the RS-DCC Termination Editor dialog box, complete the following as necessary:
• Disable OSPF on RS-DCC Link—If checked, OSPF is disabled on the link. OSPF should be
disabled only when the slot and port connect to third-party equipment that does not support OSPF.
• Far End is Foreign—Check this box to specify that the RS-DCC termination is a non-ONS node.
• Far End IP—If you checked the Far End is Foreign check box, type the IP address of the far-end
node or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the
far end.
Step 5 Click OK.
Step 6 Return to your origination procedure (NTP).
DLP-D360 Delete a Regenerator-Section DCC Termination
Note Deleting a DCC termination can cause you to lose visibility to nodes that do not have other DCCs or
network connections to the CTC computer.
Step 1 In node view, click the Provisioning > Comm Channels > RS-DCC tabs.
Step 2 Click the RS-DCC termination and click Delete. The Delete RS-DCC Termination dialog box appears.
Step 3 Click Ye s in the confirmation dialog box.
Step 4 Return to your originating procedure (NTP).
DLP-D361 Create a DCC Tunnel
Purpose This task deletes an SDH RS-DCC termination on the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task creates a DCC tunnel to transport traffic from third-party SDH
equipment across ONS 15454 SDH networks. Tunnels can be created on
the RS-DCC channel (D1-D3) (if not used by the ONS 15454 SDH as a
terminated DCC), or any MS-DCC channel (D4-D6, D7-D9, or D10-D12).
Tools/Equipment STM-N cards must be installed.
Prerequisite Procedures NTP-D127 Verify Network Turn-Up, page 6-5
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
