18-7
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D106 View and Terminate Active Logins
Note You can add up to 10 RADIUS servers to a node’s list of authenticators.
Step 8 Click Edit to make changes to an existing RADIUS server. You can change the IP address, the shared
secret, the authentication port, and the accounting port.
Step 9 Click Delete to delete the selected RADIUS server.
Step 10 Click Move Up or Move Down to reorder the list of RADIUS authenticators. The node requests
authentication from the servers sequentially from top to bottom. If one server is unreachable, the node
will request authentication from the next RADIUS server on the list.
Step 11 Click the Enable RADIUS Authentication check box to activate remote-server authentication for the
node.
Step 12 Click the Enable RADIUS Accounting check box if you want to show RADIUS authentication
information in the audit trail.
Step 13 Click the Enable the Node as the Final Authenticator check box if you want the node to be the final
autheticator. This means that if every RADIUS authenticator is unavailable, the node will authenticate
the login rather than locking the user out.
Step 14 Click Apply to save all changes or Reset to clear all changes.
Step 15 Return to your originating procedure (NTP).
DLP-D106 View and Terminate Active Logins
Step 1 In node view, click the Provisioning > Security > Active Logins tabs. The Active Logins subtab
displays the following information:
• User ID
• User IP address
• Current node the user is logged into
• Session Type (EMS, TL1, FTP, Telnet, or SSH)
• Login time
• Last activity time
Step 2 Click Logout to end the session of every logged-in user. This will log out all current users, excluding
the initiating Superuser.
Purpose This procedure allows you to view active CTC logins, retrieve the last
activity time, and terminate all current logins.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher for viewing; Superuser for session termination
To Next Page
Loading...
