17-54
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D64 Set the IP Address, Default Router, and Network Mask Using the LCD
Note The LCD reverts to normal display mode after 5 seconds of button inactivity.
Step 1 On the ONS 15454 SDH front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 2 Repeatedly press the Port button until the following displays:
• To change the node IP address, Status=IpAddress (Figure 17-12)
• To change the node network mask, Status=Net Mask
• To change the default router IP address, Status=Default Rtr
Figure 17-12 Selecting the IP Address Option
Step 3 Press the Status button to display the node IP address (Figure 17-13), the node subnet mask length, or
the default router IP address.
Figure 17-13 Changing the IP Address
Step 4
Push the Slot button to move to the IP address or subnet mask digit that you need to change. The selected
digit flashes.
Tip The Slot, Status, and Port button positions correspond to the command position on the LCD. For
example, in Figure 17-13, you press the Slot button to invoke the Next command and the Port button to
invoke the Done command.
Step 5 Press the Port button to cycle the IP address or subnet mask to the correct digit.
Step 6 When the change is complete, press the Status button to return to the Node menu.
Step 7 Repeatedly press the Port button until the Save Configuration option appears (Figure 17-14).
FAN FAIL
Slot
Slot-0
Status=IpAddress
44089
CRIT MAJ MIN
Status Port
FAN FAIL
Slot
172.020.214.107
<Next Done Mod>
44090
CRIT MAJ MIN
Status Port
To Next Page
Loading...
