Cisco ONS 15454 SDH - DLP- D190 View CE-Series Ethernet and POS Ports Utilization PM Parameters

18-78
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D190 View CE-Series Ethernet and POS Ports Utilization PM Parameters
DLP-D190 View CE-Series Ethernet and POS Ports Utilization PM Parameters
Note For CE-Series card provisioning, refer to the Ethernet Card Software Feature and Configuration Guide
for the Cisco ONS 15454, Cisco ONS 15454 SDH, and Cisco ONS 15327.
Step 1 In node view, double-click the CE-series Ethernet card where you want to view PM counts. The card
view appears.
Step 2 Click the Performance > Ether Ports > Utilization (Figure 18-13) or Performance > POS Ports >
Utilization tabs.
Figure 18-13 Ether Ports Utilization on the CE-Series Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Purpose This task enables you to view CE-Series card Ethernet and POS port
Utilization PM counts at selected time intervals to detect possible
performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124472
Performance
tab
Utilization
tab
Ether ports
tab
Card
view
Interval
drop-down list
Refresh
button
Help
button