18-26
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D131 Search for Circuits
Step 4 View the current statistics columns to observe changes to PM counts for the current time interval.
Step 5 Return to your originating procedure (NTP).
DLP-D131 Search for Circuits
Step 1 Navigate to the appropriate CTC view:
• To search the entire network, from the View menu, choose Go to Network View.
• To search for circuits that originate, terminate, or pass through a specific node, from the View menu,
choose Go to Other Node, then choose the node you want to search and click OK.
• To search for circuits that originate, terminate, or pass through a specific card, double-click the card
on the shelf graphic in node view to open the card in card view.
Step 2 Click the Circuits tab.
Step 3 If you are in node or card view, choose the scope for the search (Network or Node) in the Scope
drop-down list.
Step 4 Click Search.
Step 5 In the Circuit Name Search dialog box, complete the following:
• Find What—Enter the text of the circuit name you want to find.
• Match Whole Word Only—Check this check box to instruct CTC to select circuits only if the entire
word matches the text in the Find What field.
• Match Case—Check this check box to instruct CTC to select circuits only when the capitalization
matches the capitalization entered in the Find What field.
• Direction—Choose the direction for the search. Searches are conducted up or down from the
currently selected circuit.
Step 6 Click Find Next. If a match is found, click Find Next again to find the next circuit.
Step 7 Repeat Steps 5 and 6 until you are finished, then click Cancel.
Step 8 Return to your originating procedure (NTP).
Purpose This task searches for ONS 15454 SDH circuits at the network, node, or
card level.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
