18-16
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D114 View Conditions
Note Alarms that have been raised during the session will have a check mark in the Alarms window
New column. When you click Synchronize, the check mark disappears.
Step 3 Return to your originating procedure (NTP).
DLP-D114 View Conditions
Step 1 From card, node, or network view, click the Conditions tab.
Step 2 Click Retrieve (Figure 18-5).
The Retrieve button requests the current set of fault conditions from the node, card, or network. The
window is not updated when events change on the node. You must click Retrieve to see any changes.
Purpose Use this task to view conditions [events with a Not Reported (NR) severity]
at the card, node, or network level. The Conditions tab gives you a clear
record of changes or events that do not result in alarms.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
