18-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D102 Hard-Reset a CE-100T-8 Card Using CTC
Step 3 Click Delete.
Step 4 Return to your originating procedure (NTP).
DLP-D102 Hard-Reset a CE-100T-8 Card Using CTC
Caution Hard-resetting a CE100T-8 card causes a traffic hit.
Note The hard-reset option is enabled only when the card is placed in the Locked-disabled,maintenance
service state.
Step 1 In node view, click the Inventory tab. Locate the appropriate card in the inventory pane.
Step 2 Click the Admin State drop-down list and select Locked,maintenance. Click Apply.
Step 3 Click Ye s in the “Action may be service affecting. Are you sure?” dialog box.
Step 4 The service state of the card becomes Locked enabled, loopback & maintenance. The card’s faceplate
appears blue in Cisco Transport Controller (CTC) and the SRV LED turns amber.
Step 5 Right-click the card to reveal a shortcut menu.
Step 6 Click Hard-reset Card.
Step 7 Click Ye s in the “Are you sure you want to hard-reset this card?” dialog box.
Step 8 Return to your originating procedure (NTP).
Purpose This task hard-resets the CE100T-8 Ethernet card.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
