2-10
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 2 Install Cards and Fiber-Optic Cable
NTP- D17 Install the Electrical Cards
Step 7 The MRC-12 card requires SFPs and the STM64-XFP cards require XFPs to provide a fiber interface. If
you installed any of these cards, complete the “DLP-D335 Install GBIC or SFP/XFP Devices” task on
page 20-28 or preprovision the SFP/XFP using the “DLP-D107 Preprovision an SFP or XFP Device”
task on page 18-8.
Step 8 Continue with the “NTP-D19 Install Fiber-Optic Cables on Optical Cards” procedure on page 2-16.
Stop. You have completed this procedure.
NTP-D17 Install the Electrical Cards
Warning
During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Statement 94
Note The E3-12 card can be deployed in a central office or a carrier’s exchange.
Note Install higher-capacity cards first; for example, install an E3-12 card before installing an E1-14 card. Let
each card boot completely before installing the next card.
Note Cisco recommends installing STM-N, transponder (TXP), and muxponder (MXP) cards before you
install electrical cards, as applicable.
Step 1 If you installed XC-VXL-2.5G cards, review Table 2-1 on page 2-3 to determine card/slot compatibility.
If you installed XC-VXL-10G or XC-VXC-10G cards, review Table 2-2 on page 2-5 to determine
card/slot compatibility.
Step 2 Open the card latches/ejectors.
Step 3 Use the latches/ejectors to firmly slide the card along the guide rails until the card plugs into the
receptacle at the back of the slot.
Note If you install the wrong card in a slot, complete the “NTP-D227 Remove and Replace a Card”
procedure on page 2-20.
Purpose This procedure installs the electrical cards (DS3i-N-12, E1-N-14, E1-42,
E3-12, and STM1E-12).
Tools/Equipment Electrical cards
Prerequisite Procedures NTP-D220 Install the Power and Signal FMECs, page 1-7
NTP-D15 Install the Common Control Cards, page 2-2
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
