6-97
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D283 Create an Automatically Routed VCAT Circuit
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at an ONS 15454 SDH on the network
where you will create the overhead circuit. If you are already logged in, continue with Step 2.
Step 2 From the View menu, choose Go to Network View.
Step 3 As needed, complete the “DLP-D361 Create a DCC Tunnel” task on page 20-66.
Step 4 As needed, complete the “DLP-D4 Create an IP-Encapsulated Tunnel” task on page 17-3.
Step 5 As needed, complete the “DLP-D83 Provision Orderwire” task on page 17-76.
Step 6 As needed, complete the “DLP-D212 Create a User Data Channel Circuit” task on page 19-9.
Stop. You have completed this procedure.
NTP-D283 Create an Automatically Routed VCAT Circuit
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you will create the VCAT
circuit. If you are already logged in, continue with Step 2.
Step 2 Complete the following as necessary (you can provision Ethernet or POS ports before or after the VCAT
circuit is created):
• To provision Ethernet ports for CE-100T-8 circuits, complete the “DLP-D136 Provision CE-100T-8
Ethernet Ports” task on page 18-30.
• To provision Ethernet ports for CE-1000-4 circuits, complete the “DLP-D211 Provision CE-1000-4
Ethernet Ports” task on page 19-8.
• To provision POS ports for CE-100T-8 or CE-1000-4 circuits, complete the “DLP-D141 Provision
CE-100T-8 and CE-1000-4 POS Ports” task on page 18-33.
• To provision Ethernet ports for ML-Series circuits, complete the “DLP-D493 Provision the Ethernet
Port of the ML-Series Card” task on page 21-49.
• To provision POS ports for ML-Series circuits, complete the “DLP-D494 Provision the POS Port of
the ML-Series Card” task on page 21-50.
Step 3 From the View menu, choose Go to Network View.
Step 4 Click the Circuits tab, then click Create.
Step 5 In the Circuit Creation dialog box, choose VC_HO_PATH_VCAT_CIRCUIT from the Circuit Type
drop-down list.
Step 6 Click Next.
Purpose This procedure creates an automatically routed VCAT circuit. For more
information about VCAT circuits, refer to the “Circuits and Tunnels”
chapter in the Cisco ONS 15454 SDH Reference Manual.
Tools/Equipment ML-Series, CE-100T-8, CE-1000-4, or FC_MR-4 cards must be installed
at the nodes used in the VCAT circuit.
Prerequisite Procedures NTP-D127 Verify Network Turn-Up, page 6-5
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
