18-34
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D142 Modify a Static Route
Note You can provision SONET CCAT or VCAT circuits for the CE-100T-8 or CE-1000-4 before or after
provisioning the card’s Ethernet and/or POS ports. See the “NTP-D323 Create an Automatically Routed
High-Order Circuit” procedure on page 6-55 or the “NTP-D283 Create an Automatically Routed VCAT
Circuit” procedure on page 6-97, as needed.
Step 1 In node view, double-click the CE-100T-8 or CE-1000-4 card graphic to open the card.
Step 2 Click the Provisioning > POS Ports tabs.
Step 3 For each CE-100T-8 or CE-1000-4 port, provision the following parameters:
• Port Name—If you want to label the port, enter the port name.
Note Circuit table displays port name of the POS port and not the Ethernet port.
• Admin State—Choose Unlocked to put the port in service.
• Framing Type—Choose GPF-F POS framing (the default) or HDLC POS framing. The framing
type needs to match the framing type of the POS device at the end of the SONET circuit.
• Encap CRC—With GFP-F framing, the user can configure a 32-bit cyclic redundancy check (CRC)
(the default) or none (no CRC). HDLC framing provides a set 32-bit CRC. The CRC should be set
to match the CRC of the POS device on the end of the SONET circuit.
Note For more details about the interoperability of ONS Ethernet cards, including information on
encapsulation, framing, and CRC, refer to the “POS on ONS Ethernet Cards” chapter of the
Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
Note The CE-100T-8 and CE-1000-4 cards use LEX encapsulation, which is the primary POS
encapsulation used in ONS Ethernet cards.
Step 4 Click Apply.
Step 5 Refresh the POS statistics:
a. Click the Performance > POS Ports > Statistics tabs.
b. Click Refresh.
Step 6 Return to your originating procedure (NTP).
DLP-D142 Modify a Static Route
Purpose This task modifies a static route on an ONS 15454 SDH.
Tools/Equipment None
To Next Page
Loading...
