18-33
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D141 Provision CE-100T-8 and CE-1000-4 POS Ports
Note Changing the date, time, or time zone might invalidate the node’s performance monitoring counters.
Step 1 In node view, click the Provisioning > General tabs.
Step 2 Change any of the following:
• General: Node Name
• General: Contact
• Location: Latitude
• Location: Longitude
• Location: Description
Note To see changes to longitude or latitude on the network map, you must go to network view and
right-click the specified node, then click Reset Node Position.
• Time: Use NTP/SNTP Server
• Time: Date (M/D/Y)
• Time: Time (H:M:S)
• Time: Time Zone
• Time: Use Daylight Saving Time
See the “NTP-D316 Set Up Name, Date, Time, and Contact Information” procedure on page 4-4 for
detailed field descriptions.
Step 3 Click Apply. Confirm that the changes appear; if not, repeat the task.
Step 4 Return to your originating procedure (NTP).
DLP-D141 Provision CE-100T-8 and CE-1000-4 POS Ports
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task provisions CE-100T-8 or CE-1000-4 POS ports to carry traffic.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
