20-68
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D362 Delete a Multiplex-Section DCC Termination
Step 9 Put the ports that are hosting the DCC tunnel in service. See the “DLP-D214 Change the Service State
for a Port” task on page 19-10 for instructions.
Step 10 Return to your originating procedure (NTP).
DLP-D362 Delete a Multiplex-Section DCC Termination
Caution Deleting a DCC termination can cause you to lose visibility of nodes that do not have other DCCs or
network connections to the CTC computer.
Step 1 In node view, click the Provisioning > Comm Channel > MS-DCC tabs.
Step 2 Click the MS-DCC termination to be deleted and click Delete. The Delete MS-DCC Termination dialog
box appears.
Step 3 Click Ye s in the confirmation dialog box. Confirm that the changes appear; if not, repeat the task.
Step 4 Return to your originating procedure (NTP).
DLP-D363 Provision Regenerator-Section DCC Terminations
Purpose This task deletes an SDH MS-DCC termination on the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task creates the SDH RS-DCC terminations required for alarms,
administration data, signal control information, and messages. In this task,
you can also set up the node so that it has direct IP access to a far-end
non-ONS node over the DCC network. In addition, this task can create an
OSI subnetwork point of attachment on the DCC to allow the node to be
networked with third-party network elements (NEs) that are based on the
OSI protocol stack.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
