20-61
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D355 Change Distance Extension Port Settings for the FC_MR-4 Card
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
DLP-D355 Change Distance Extension Port Settings for the FC_MR-4 Card
Note For the default values and domains of user-provisionable card settings, refer to the “Network Element
Defaults” appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 2 Click the Provisioning > Port > Distance Extension tabs.
Step 3 Modify any of the settings described in Table 20-28 by clicking in the field you want to modify. In some
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
Link Recovery Enables or disables link recovery if a local
port is inoperable. If enabled, a link reset
occurs when there is a loss of transport from
a cross-connect switch, protection switch,
or an upgrade.
—
Media Type Sets the proper payload value for the
Transparent Generic Framing Protocol
(GFP-T) frames.
• Fibre Channel - 1 Gbps
• Fibre Channel - 2 Gbps
• FICON 1 Gbps
• FICON 2 Gbps
• Unknown
Purpose This task changes the distance extension parameters for FC_MR-4 ports.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 20-27 FC_MR-4 Card General Port Settings (continued)
Parameter Description Options
To Next Page
Loading...
