Cisco ONS 15454 SDH - DLP- D77 Delete a Member from a VCAT Circuit

17-69
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D77 Delete a Member from a VCAT Circuit
f. Repeat Steps c through e until the member is provisioned from the source to the destination node
through all intermediary nodes. If you selected Fully Protect Path, you must:
• Add two spans for each SNCP ring or unprotected portions of the member route from the source
to the destination.
• Add one span for each MS-SPRing or 1+1 portions of route from the source to the destination.
• For members routed on SNCP dual-ring interconnect (DRI) topologies, provision the working
and protect paths as well as spans between the DRI nodes.
g. Repeat Steps a through f for each member.
Step 11 If you checked Route Automatically in Step 7 and checked Review Route Before Creation, complete the
following substeps. If not, continue with Step 12.
a. Click Next.
b. Review the circuit route. To add or delete a circuit span, choose a node on the circuit route. Blue
arrows show the circuit route. Green arrows indicate spans that you can add. Click a span arrowhead,
then click Include to include the span or Remove to remove the span.
c. If the provisioned circuit does not reflect the routing and configuration you want, click Back to
verify and change circuit information.
Step 12 Click Finish.
Note Adding members to a VCAT circuit might take several minutes depending on the complexity of
the network and the number of members to be added.
Step 13 Return to your originating procedure (NTP).
DLP-D77 Delete a Member from a VCAT Circuit
Purpose This task removes a member from a SW-LCAS VCAT circuit on an
FC_MR-4 (enhanced mode) card. This task reduces the size of the VCAT
circuit.
Tools/Equipment FC_MR-4 card (enhanced mode)
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
A SW-LCAS VCAT circuit with a source or destination on an FC_MR-4
card (enhanced mode) must exist. See Chapter 6, “Create Circuits and
Low-Order Tunnels.”
As necessary, complete the “DLP-D80 Change a VCAT Member Service
State” task on page 17-72 to change a SW-LCAS member state to
Locked-enabled,outOfGroup.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher