Cisco ONS 15454 SDH - Perform a Terminal (Inward) Loopback on a Source-Node MXP;TXP;FC_MR Port

1-18
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 1 Install the Shelf and FMECs
NTP- D13 Perform the Shelf Installation Acceptance Test
Figure 1-4 ONS 15454 SDH FMEC Cover
Step 4
Attach the ground wire to the shelf.
Step 5 Attach the washer and nut.
Step 6 Attach the cover to the shelf using the screws on the top of the cover.
Stop. You have completed this procedure.
NTP-D13 Perform the Shelf Installation Acceptance Test
Step 1 Complete Table 1-2 by verifying that each applicable procedure was completed.
71087
F
A
N
F
A
IL
C
R
IT
M
A
J
M
IN
Pin hinge
FMEC cover
Hinge-locking
spring
Purpose Use this procedure to perform a shelf installation acceptance test.
Tools/Equipment Voltmeter
Oval and/or block ferrites
Prerequisite Procedures Applicable procedures in Chapter 1, “Install the Shelf and FMECs.”
Required/As Needed Required
Onsite/Remote Onsite
Security Level None