Cisco ONS 15454 SDH - Selecting the Save Configuration Option

17-55
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D64 Set the IP Address, Default Router, and Network Mask Using the LCD
Figure 17-14 Selecting the Save Configuration Option
Step 8
Press the Status button to choose the Save Configuration option.
A Save and REBOOT message appears (Figure 17-15).
Figure 17-15 Saving and Rebooting the TCC2/TCC2P
Step 9
Press the Slot button to apply the new IP address configuration, or press Port to cancel the configuration.
Saving the new configuration causes the TCC2/TCC2P cards to reboot. During the reboot, a “Saving
Changes - TCC Reset” message displays on the LCD. The LCD returns to the normal alternating display
after the TCC2/TCC2P reboot is complete (see Table 19-4 on page 19-55 for reboot behavior).
Note The IP address and default router must be configured to be on the same subnet. If not, you cannot
apply the configuration.
Step 10 Return to your originating procedure (NTP).
FAN FAIL
Slot
Slot-0
Status=Save Cfg.
44091
CRIT MAJ MIN
Status Port
FAN FAIL
Slot
Save and REBOOT?
<Apply Revert>
44092
CRIT MAJ MIN
Status Port