18-49
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D158 Change User Password and Security Level on a Single Node
• Facility Type: E1, 2 MHz
• BITS In State
• BITS Out State
• Coding
• Framing
• Sync Messaging
• Admin SSM
• AIS Threshold
• Sa Bit
Step 6 Click Apply.
Note Refer to the “Timing” chapter in the Cisco ONS 15454 SDH Reference Manual for timing
information.
Step 7 Return to your originating procedure (NTP).
DLP-D158 Change User Password and Security Level on a Single Node
Step 1 In node view, click the Provisioning > Security > Users tabs.
Step 2 Click the user whose settings you want to modify.
Step 3 Click Change.
Step 4 In the Change User dialog box, you can:
• Change the existing user password
• Change the existing user security level
• Lock out the user
See the “NTP-D30 Create Users and Assign Security” procedure on page 4-4 for fields and descriptions.
Step 5 Click OK.
Note User settings that you changed during this task will not appear until that user logs off and logs
back in.
Purpose This task changes settings for an existing user at one node.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
