Cisco ONS 15454 SDH - DLP- D36 Provision a VCAT Circuit Source and Destination

17-28
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D36 Provision a VCAT Circuit Source and Destination
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the node that you want to delete.
Step 3 From the CTC File menu, click Delete Selected Node.
After a few seconds, the node disappears from the network view map.
Step 4 Return to your originating procedure (NTP).
DLP-D36 Provision a VCAT Circuit Source and Destination
Step 1 From the Node drop-down list, choose the node where the circuit will originate.
Step 2 From the Slot drop-down list, choose the slot containing the ML-Series or FC_MR-4 card where the
circuit will originate. (If a card’s capacity is fully utilized, it does not appear in the list.)
Step 3 Depending on the circuit origination card, choose the source port and/or VC from the Port and VC4 or
VC3 drop-down lists. The Port drop-down list is only available if the card has multiple ports. VCs do
not appear if they are already in use by other circuits.
Step 4 Click Next.
Step 5 From the Node drop-down list, choose the destination node.
Step 6 From the Slot drop-down list, choose the slot containing the ML-Series or FC_MR-4 card where the
circuit will terminate (destination card). (If a card’s capacity is fully utilized, the card does not appear
in the list.)
Step 7 Depending on the card selected in Step 2, choose the source port and/or VC from the Port and VC4 or
VC3 drop-down lists. The Port drop-down list is only available if the card has multiple ports. VCs do
not appear if they are already in use by other circuits.
Step 8 Click Next.
Step 9 Return to your originating procedure (NTP).
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task provisions a VCAT circuit source and destination.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
The Source page of the Circuit Creation wizard must be open.
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher