17-33
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D41 Delete a Provisionable Patchcord
DLP-D41 Delete a Provisionable Patchcord
Note Deleting the last DCC termination on an optical port automatically deletes all provisionable patchcords
provisioned on the port. If the port is in a 1+1 protection group, CTC automatically deletes the patchcord
link on the protection port.
Step 1 In node view, click the Provisioning > Comm Channels > Provisionable Patchcords tabs. If you are
in network view, click the Provisioning > Provisionable Patchcords tabs.
Step 2 Click the provisionable patchcord that you want to delete.
Step 3 Click Delete.
Step 4 In the confirmation dialog box, click Yes .
Step 5 Return to your originating procedure (NTP).
DLP-D42 Install Fiber-Optic Cables on an LGX Interface
Step 1 Align the keyed ridge of the cable connector with the receiving SC connector on the LGX faceplate
connection point. Each card supports at least one transmit and one receive connector to create an optical
carrier port.
Note The OC12 IR/STM4 SH 1310-4 and the OC3 IR 4/STM1 SH 1310 (multiport) card faceplates
have four ports.
Purpose This task deletes a provisionable patchcord.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
DLP-D40 Create a Provisionable Patchcord, page 17-31
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning and higher
Purpose This task installs fiber-optic cables on the Lightguide Cross Connect (LGX)
interface in the Central Office.
Tools/Equipment Fiber-optic cables
Prerequisite Procedures NTP-D112 Clean Fiber Connectors, page 15-15
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
