Cisco ONS 15454 SDH - DLP- D51 Set up a Windows PC for Craft Connection to an ONS 15454 SDH Using Dynamic Host Configuration Protocol

17-39
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D51 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using Dynamic Host Configuration Protocol
i. In the Local Area Connection Properties dialog box, click OK.
j. In the Local Area Connection Status dialog box, click Close.
Step 6 If you have Windows XP installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Control Panel > Network Connections.
Note If the Network Connections menu item is not available, click Switch to Classic View.
b. From the Network Connections dialog box, click the Local Area Connection icon.
c. From the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then
click Properties.
d. In the IP Address field, enter an IP address that is identical to the ONS 15454 SDH IP address except
for the last octet. The last octet must be 1 or 3 through 254.
e. In the Subnet Mask field, type 255.255.255.0.
f. In the Default Gateway field, type the ONS 15454 SDH IP address.
g. Click OK.
h. In the Local Area Connection Properties dialog box, click OK.
i. In the Local Area Connection Status dialog box, click Close.
Step 7 Return to your originating procedure (NTP).
DLP-D51 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH Using
Dynamic Host Configuration Protocol
Note Do not use this task for initial node turn-up. Use the task only if DHCP forwarding is enabled on the
ONS 15454 SDH. By default, DHCP is not enabled. To enable it, see the “NTP-D169 Set Up CTC
Network Access” procedure on page 4-7.
Note The ONS 15454 SDH does not provide the IP addresses. If DHCP forwarding is enabled, it passes DCHP
requests to an external DHCP server.
Purpose This task sets up your computer for craft connection to the
ONS 15454 SDH using Dynamic Host Configuration Protocol (DHCP).
Tools/Equipment None
Prerequisite Procedures NTP-D278 Set Up Computer for CTC, page 3-2
NTP-D169 Set Up CTC Network Access, page 4-7
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None