6-95
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 6 Create Circuits and Low-Order Tunnels
NTP- D149 Test G-Series Circuits
Figure 6-12 Two-Port Unidirectional Transponder Mode
Stop. You have completed this procedure.
NTP-D149 Test G-Series Circuits
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the ONS 15454 SDH source Ethernet
node. If you are already logged in, continue with Step 2.
Step 2 Complete the “DLP-D230 Change a Circuit State” task on page 19-26 and change the circuit and circuit
ports to the Locked-enabled,maintenance service state.
Purpose This procedure tests circuits created on G-Series Ethernet cards.
Tools/Equipment Ethernet test set and appropriate fibers
Prerequisite Procedures This procedure assumes that you completed facility loopback tests to test
the fibers and cables from the source and destination ONS 15454 SDHs to
the fiber distribution panel or the DSX, and one of the following
procedures:
NTP-D323 Create an Automatically Routed High-Order Circuit, page 6-55
NTP-D324 Create a Manually Routed High-Order Circuit, page 6-60
NTP-D148 Create a Manual Cross-Connect for a G-Series or E-Series Card
in Port-Mapped Mode, page 6-90
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
