17-37
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D50 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH on the Same Subnet Using Static IP
DLP-D50 Set Up a Windows PC for Craft Connection to an ONS 15454 SDH on the
Same Subnet Using Static IP Addresses
Step 1 Verify the operating system that is installed on your computer:
a. From the Windows Start menu, choose Settings > Control Panel.
Note In Windows XP, you can choose Control Panel directly from the Start menu. Make sure you
are in Classic View before continuing with this procedure.
b. In the Control Panel window, double-click the System icon.
c. On the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 98, Windows NT 4.0, Windows 2000, or Windows XP.
Step 2 According to the Windows operating system installed on your computer, perform one of the following
steps:
• For Windows 98, complete Step 3.
• For Windows NT 4.0, complete Step 4.
• For Windows 2000, complete Step 5.
• For Windows XP, complete Step 6.
Step 3 If you have Windows 98 installed on your PC, complete the following steps to change its TCP/IP
configuration:
a. From the Windows Start menu, choose Settings > Control Panel.
b. In the Control Panel dialog box, click the Network icon.
c. In the Network dialog box, choose TCP/IP for your network interface card (NIC), then click
Properties.
d. In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
e. Click the WINS Configuration tab and choose Disable WINS Resolution.
f. Click the IP Address tab.
g. In the IP Address window, click Specify an IP address.
Purpose This task sets up your computer for a local craft connection to the
ONS 15454 SDH when:
• You will connect to one ONS 15454 SDH; if you will connect to
multiple ONS 15454 SDH nodes, you might need to reconfigure your
computer’s IP settings each time you connect to an ONS 15454 SDH.
• You need to use non-ONS 15454 SDH applications such as ping and
tracert (trace route).
Tools/Equipment None
Prerequisite Procedures NTP-D278 Set Up Computer for CTC, page 3-2
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level None
To Next Page
Loading...
