1-13
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 1 Install the Shelf and FMECs
NTP- D222 Install the E1-75/120 Conversion Panel
Stop. You have completed this procedure.
NTP-D222 Install the E1-75/120 Conversion Panel
Note For more information about the E1-75/120 conversion panel, refer to the Cisco ONS 15454 SDH
Reference Manual.
Step 1 Lift the E1-75/120 conversion panel to the desired rack position.
Figure 1-3 shows the rack-mounting for the E1-75/120 conversion panel.
Purpose This procedure installs the E1-75/120 conversion panel. You need an
E1-75/120 conversion panel if you want to convert the balanced 120-ohm
interfaces of the E1-42 card and the corresponding FMECs to unbalanced
75-ohm interfaces.
Tools/Equipment #2 Phillips screwdriver
Medium slot-head screwdriver
Small slot-head screwdriver
96-conductor cables with Molex 96-pin LFH connectors
Prerequisite Procedures NTP-D2 Install the Shelf Assembly, page 1-5
NTP-D3 Open and Remove the Front Door, page 1-6
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
