Cisco ONS 15454 SDH - Table 20-18 Line Options for the Ds3 I-N-12 Cards

20-48
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D341 Change Line and Threshold Settings for the DS3i-N-12 Cards
SF BER Sets the signal fail bit error rate. • 1E-3
• 1E-4
• 1E-5
SD BER Sets the signal degrade bit error rate.
• 1E-5
• 1E-6
• 1E-7
• 1E-8
• 1E-9
Line Type Defines the line framing type.
• Unframed
• M13
• C Bit
• Auto Provisioned
Detected
Line Type
(Display only) Displays the detected line
type.
• Unframed
• M13
• C Bit
• Auto Provisioned
Line
Coding
(Display only) Defines the DS3E
transmission coding type.
B3ZS
Line
Length
Defines the distance (in feet) from
backplane connection to the next
termination point.
• 0 - 225 (Default)
• 226 - 450
Admin
State
Sets the port service state unless network
conditions prevent the change. For more
information about administrative states,
refer to the “Administrative and Service
States” appendix of the
Cisco ONS 15454 SDH Reference
Manual.
• Unlocked—Puts the port in service. The
port service state changes to
Unlocked-enabled.
• Unlocked,automaticInService—Puts the
port in automatic in-service. The port
service state changes to
Unlocked-disabled,automaticInService.
• Locked,disabled—Removes the port
from service and disables it. The port
service state changes to
Locked-enabled,disabled.
• Locked,maintenance—Removes the port
from service for maintenance. The port
service state changes to
Locked-enabled,maintenance.
Table 20-18 Line Options for the DS3i-N-12 Cards (continued)
Parameter Description Options