Cisco ONS 15454 SDH - DLP- D342 Change Line and Threshold Settings for the STM1 E-12 Card

20-51
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D342 Change Line and Threshold Settings for the STM1E-12 Card
DLP-D342 Change Line and Threshold Settings for the STM1E-12 Card
Note For the default values and domains of user-provisionable card settings, refer to the “Network Element
Defaults” appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the STM1E-12 card where you want to change the line or threshold settings.
Step 2 Click the Provisioning tab.
Step 3 Depending on the setting you need to modify, click the Line, Port, SDH Thresholds, or VC4 subtab.
Note See Chapter 9, “Manage Alarms” for information about the Alarm Profiles tab.
Note If you want to modify a threshold setting, it might be necessary to click on the available
directional, type, and interval (15 Min, 1 Day) radio buttons and then click Refresh. This will
display the desired threshold setting.
Step 4 Modify any of the settings found under these subtabs by clicking in the field you want to modify. In some
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
Step 5 Click Apply.
Step 6 Repeat Steps 3 through 5 for each subtab that has parameters you want to provision.
Step 7 For definitions of the line settings, see Table 20-22. For definitions of the port settings, see Table 20-23
on page 20-52. For definitions of the threshold settings, see Table 20-24 on page 20-53. For definitions
of the VC4 settings, see Table 20-25 on page 20-53.
Table 20-22 describes the values on the Provisioning > Line tab for the STM1E-12 cards.
Purpose This task changes the line and threshold settings for the STM1E-12 card.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 20-22 Line Options for the STM1E-12 Card
Parameter Description Options
Port (Display only) Port number. 1 to 12
Port Name (Optional) Sets the name assigned to
the port.
User-defined, up to 32 alphanumeric/special
characters. Blank by default.
See the “DLP-D314 Assign a Name to a Port”
task on page 20-7.