10-6
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 10 Change Card Settings
NTP- D331 Manage Pluggable Port Modules
Step 3 Click Admin State for the card or PPM you want to change, and choose an administrative state from the
drop-down list: Unlocked or Locked,maintenance.
Step 4 Click Apply.
Step 5 If an error message opens indicating that the card or PPM state cannot be changed from its current state,
click OK.
Depending on the Admin State you choose, the card or port/PPM transitions to a different service state.
For more information about the service states and card state transitions, refer to the “Administrative and
Service States” appendix of the Cisco ONS 15454 SDH Reference Manual.
Stop. You have completed this procedure.
NTP-D331 Manage Pluggable Port Modules
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49 at the node where you want to provision,
change, or delete PPMs. If you are already logged in, continue with Step 2.
Step 2 From the View menu, choose Go to Network View.
Step 3 Click the Alarms tab:
a. Verify that the alarm filter is not turned on. See the DLP-D227 Disable Alarm Filtering, page 19-25
as necessary.
b. Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15454 SDH Troubleshooting Guide.
c. Complete the “DLP-D147 Export CTC Data” task on page 18-38 to export alarm and condition
information.“DLP-D132 Provision a Multirate PPM on the MRC-12 Card” task on page 18-27
Step 4 As needed, complete the “DLP-D132 Provision a Multirate PPM on the MRC-12 Card” task on
page 18-27. Single-rate PPMs do not require provisioning.
Step 5 As needed, complete the “DLP-D133 Provision the Optical Line Rate on the MRC-12 Card” task on
page 18-27 to assign an OC-3, OC-12, or OC-48 line rate.
Step 6 As needed, complete the “DLP-D134 Change the Optical Line Rate on the MRC-12 Card” task on
page 18-28 to change the line rate on a multirate PPM. You cannot change the optical line rate on
single-rate PPMs.
Step 7 As needed, complete the “DLP-D135 Delete a PPM from the MRC-12 or STM64-XFP Card” task on
page 18-29.
Purpose This procedure provisions, changes, and deletes PPMs for the MRC-12 and
STM64-XFP cards. (STM64-XFP cards are single-rate PPMs, and
therefore can only be deleted.)
Tools/Equipment None
Prerequisite Procedures DLP-D107 Preprovision an SFP or XFP Device, page 18-8 or
DLP-D335 Install GBIC or SFP/XFP Devices, page 20-28
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
