Cisco ONS 15454 SDH - Chapter 16 Power down the Node

16-2
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 16 Power Down the Node
NTP- D114 Power Down the Node
Step 3 In network view, verify that the node is not connected to a network.
a. If the node is part of a working network, log out of the node and complete the “NTP-D322 Remove
an In-Service Node from a Linear ADM” procedure on page 14-18, the “NTP-D213 Remove an
MS-SPRing Node” procedure on page 14-7, or the “NTP-D106 Remove an SNCP Node” procedure
on page 14-12. If the node is part of a Software R6.0 MSTP configuration, consult your network
administrator. (Linear configurations will be deleted in Step 5.) Continue with the next step.
b. If the node is not connected to a working network and the current configurations are no longer
required, continue with the next step.
Note Current configurations will be saved if Steps 4 through 13 are skipped.
Step 4 In node view, click the Circuits tab and verify that no circuits are displayed, then proceed to Step 5. If
circuits appear, delete all the circuits that originate or terminate in the node, as follows:
a. Click the circuits that need to be deleted and click Delete.
b. Click Yes .
Repeat until no circuits appear.
Step 5 In node view, click the Provisioning > Protection tabs and delete all protection groups:
a. Click the protection group that needs to be deleted and click Delete.
b. Click Yes .
Repeat until no protection groups appear.
Step 6 In node view, click the Provisioning > Comm Channels tabs and delete all RS-DCC, MS-DCC, GCC,
or OSC terminations:
a. Click the regenerator section data communications channel (RS-DCC), multiplex section data
communications channel (MS-DCC), generic communications channel (GCC), or optical service
channel (OSC) termination that needs to be deleted and click Delete.
b. Click Yes .
Repeat until no RS-DCC, MS-DCC, GCC, or OSC terminations are present.
Note Before deleting the OSC termination, make sure the Ring ID is deleted. Click the Provisioning >
Comm Channels > OSC tabs. Select the Ring ID and click Delete.
Step 7 For each installed STM-N or DS-N card, make sure all ports are in Locked-enabled,disabled service
state:
a. In card view, click the Provisioning > Line tabs.
b. Click under the Status column for each port and choose Locked,disabled.
Step 8 Remove all fiber connections to the cards.
Step 9 In node view, right-click an installed card and click Delete.
Step 10 Click Yes .
Step 11 After you have deleted the card, open the card ejectors and remove it from the node.
Step 12 Repeat Steps 7 through 11 for each installed card.