21-24
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D435 Change the Default Network View Background Map
Note If you are uninstalling the JRE, click Remove.
Step 13 In the Cisco Transport Controller Installation wizard, click Next. The Online User Manuals installs.
Step 14 Click Finish.
Note Be sure to record the names of the directories you choose for JRE and the online user manuals.
Step 15 Return to your originating procedure (NTP).
DLP-D435 Change the Default Network View Background Map
Note If you modify the background image, the change is stored in your CTC user profile on the computer. The
change does not affect other CTC users.
Step 1 From the Edit menu, choose Preferences > Map and check the Use Default Map check box.
Step 2 Change the left and right Latitude and Longitude for the map.
Step 3 Click the Provisioning > Defaults tabs.
Step 4 In the Defaults Selector area, choose CTC and then Network.
Step 5 Click the Default Value field and choose a default map from the drop-down list. Map choices are:
Germany, Japan, Netherlands, South Korea, United Kingdom, and the United States (default).
Step 6 Click Apply. The new network map appears.
Step 7 Click OK.
Step 8 If the ONS 15454 SDH icons are not visible, right-click the network view and choose Zoom Out. Repeat
until all the ONS 15454 SDH icons are visible. (You can also choose Fit Graph to Window.)
Step 9 If you need to reposition the node icons, drag and drop them one at a time to a new location on the map.
Step 10 If you want to change the magnification of the icons, right-click the network view and choose Zoom In.
Repeat until the ONS 15454 SDH icons appear at the magnification you want.
Step 11 Return to your originating procedure (NTP).
Purpose This task changes the default map of the CTC network view.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
