18-53
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D163 Delete SNMP Trap Destination
Step 5 In the Host and Community areas, enter the IP address of the GNE through which the ONS 15454 SDH
with the information to be retrieved can be reached.
Step 6 In the Community area, enter the community string as explained in Step 2.
Step 7 Return to your originating procedure (NTP).
DLP-D163 Delete SNMP Trap Destination
Step 1 In node view, click the Provisioning > SNMP tabs.
Step 2 In the Trap Destinations area, click the trap you want to delete.
Step 3 Click Delete. A confirmation dialog box appears.
Step 4 Click Ye s. Confirm that the changes appear; if not, repeat the task.
Step 5 Return to your originating procedure (NTP).
DLP-D165 Provision OSI Routing Mode
Caution Do not complete this task until you confirm the role of the node within the network. It will be either an
ES, IS Level 1, or IS Level 1/Level 2. This decision must be carefully considered. For additional
information about OSI provisioning, refer to the “Management Network Connectivity” chapter of the
Cisco ONS 15454 SDH Reference Manual.
Purpose This task deletes SNMP trap destinations on an ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task provisions the Open System Interconnection (OSI) routing mode.
Complete this task when the ONS 15454 SDH is connected to networks
with third party network elements (NEs) that use the OSI protocol stack for
data communications network (DCN) communication.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
To Next Page
Loading...
