18-81
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D193 Grant Superuser Privileges to a Provisioning User
Step 3 Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Port # columns. For PM parameter definitions, refer to the “Performance Monitoring” chapter in the
Cisco ONS 15454 SDH Reference Manual.
Note To refresh, reset, or clear PM counts, see the “NTP-D257 Change the PM Display” procedure
on page 8-2.
Step 5 Return to your originating procedure (NTP).
DLP-D193 Grant Superuser Privileges to a Provisioning User
Step 1 In node view, click the Provisioning > Defaults tabs.
Step 2 In the Defaults Selector area, choose NODE > security > grantPermission.
Step 3 Click in the Default Value column for the default property you are changing and choose Provisioning
from the drop-down list.
Note If you click Reset before you click Apply, all values will return to their original settings.
Step 4 Click Apply.
A pencil icon appears next to the default name that will be changed as a result of editing the defaults file.
Note You must close your current CTC session and restart a new CTC session for the changes to take
effect.
Step 5 Return to your originating procedure (NTP).
Purpose This task enables Provisioning users to perform tasks such as retrieving
audit logs, restoring databases, and activating and reverting software loads.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
