17-53
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D62 Add a Node to the Current Session or Login Group
DLP-D62 Add a Node to the Current Session or Login Group
Step 1 From the CTC File menu, click Add Node.
Step 2 In the Add Node dialog box, enter the node name (or IP address).
Note If the ONS 15454 SDH node that you want to add has TCC2P cards installed and the TCC2P
secure mode option is enabled, enter the MIC-C/T/P LAN port IP address.
Step 3 If you want to add the node to the current login group, check Add node to current login group.
Otherwise, leave it unchecked.
Note This check box is active only if you selected a login group when you logged into CTC.
Step 4 Click OK.
After a few seconds, the new node appears on the network view map.
Step 5 Return to your originating procedure (NTP).
DLP-D64 Set the IP Address, Default Router, and Network Mask Using the LCD
Note You cannot perform this task if the LCD IP Display on the node view Provisioning > Network tab is set
to Display Only or Suppress Display. See the “DLP-D249 Provision IP Settings” task on page 19-52 to
view or change the LCD IP Display field.
Purpose This task adds a node to the current CTC session or login node group.
Tools None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task changes the ONS 15454 SDH IP address, default router, and
network mask using the front panel LCD. Use this task if you cannot log
into CTC.
Tools/Equipment None
Prerequisite Procedures DLP-D332 Install the TCC2/TCC2P Cards, page 20-22
Required/As Needed As needed
Onsite/Remote Onsite
Security Level None
To Next Page
Loading...
