11-5
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 11 Change Node Settings
NTP- D203 Modify or Delete Card Protection Settings
NTP-D203 Modify or Delete Card Protection Settings
Caution Modifying and deleting protection groups can be service affecting.
Step 1 Compete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Step 2 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Step 3 Perform any of the following tasks as needed:
• DLP-D150 Modify a 1:1 Protection Group, page 18-42
• DLP-D152 Modify a 1:N Protection Group, page 18-44
• DLP-D154 Modify a 1+1 Protection Group, page 18-46
• DLP-D155 Delete a Protection Group, page 18-47
Step 4 Complete the “NTP-D108 Back Up the Database” procedure on page 15-5.
Stop. You have completed this procedure.
NTP-D277 Modify or Delete Communications Channel
Terminations and Provisionable Patchcords
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
Step 2.
Purpose This procedure modifies or deletes card protection settings.
Tools/Equipment None
Prerequisite Procedures NTP-D170 Create Protection Groups, page 4-10
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This procedure changes or deletes RS-DCC or MS-DCC terminations and
deletes provisionable patchcords on the ONS 15454 SDH.
Tools/Equipment None
Prerequisite Procedures DLP-D363 Provision Regenerator-Section DCC Terminations, page 20-68
DLP-D364 Provision Multiplex-Section DCC Terminations, page 20-71
DLP-D40 Create a Provisionable Patchcord, page 17-31
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
