15-17
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 15 Maintain the Node
NTP- D266 View E-Series Ethernet Maintenance Information
Step 2 In node view, double-click a G-Series Ethernet card. The card view appears.
Step 3 To view loopback status, click the Maintenance > Loopback tabs.
The Admin State and Service State columns identify the port number and current service state.
Administrative states include Unlocked; Locked,disabled; Unlocked,maintenance; and Unlocked,
automaticInService. Service states include Locked-Enabled, loopback & maintenance; Locked-Enabled,
disabled; Locked-Enabled, maintenance; Unlocked-Disabled, automaticInService; and
Unlocked-Enabled. The Loopback Type column identifies the type of loopback (None, Terminal
[Inward], or Facility [Line]) applied to each port on the card.
Step 4 To view Ethernet bandwidth utilization, click the Maintenance > Bandwidth tabs.
Step 5 Click Retrieve Bandwidth Usage.
The current STS bandwidth usage information appears.
Step 6 To view J1 path trace information, click the Maintenance > Path Trace tabs and then click Retrieve.
Stop. You have completed this procedure.
NTP-D266 View E-Series Ethernet Maintenance Information
Step 1 Complete the “DLP-D60 Log into CTC” task on page 17-49. If you are already logged in, continue with
the next step.
Step 2 To view spanning tree information, in node view click the Maintenance > Ether Bridge >
Spanning Trees tabs.
Step 3 As needed, complete the following tasks:
• DLP-D309 View Ethernet MAC Address Table, page 20-4
• DLP-D310 View Ethernet Trunk Utilization, page 20-5
Stop. You have completed this procedure.
Purpose This procedure enables you to view spanning tree, MAC address, and
and trunk utilization information on a selected E-Series Ethernet card.
Tools/Equipment None
Prerequisite Procedures NTP-D18 Install Ethernet Cards and Connectors, page 2-11
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
To Next Page
Loading...
