17-80
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D87 Disable Node Security Mode
• Subnet Mask
• Default Router
• LCD IP Setting—Choose one of the following:
–
Allow Configuration—Displays the MIC-C/T/P IP address on the LCD and allows it to be
changed using the LCD buttons.
–
Display only—Displays the MIC-C/T/P IP address on the LCD but does not allow it to be
changed using the LCD buttons.
–
Suppress Display—Suppresses the display of the IP address on the LCD.
• Suppress CTC IP Address—If checked, suppresses the IP address from display on the Data Comm
subtab, CTC node view information area, and other locations.
Step 3 Click Apply.
If you changed the IP address, subnet mask, or default router, the node will reboot. This will take 5 to
10 minutes.
Step 4 Return to your originating procedure (NTP).
DLP-D87 Disable Node Security Mode
Note The node will reboot after you complete this task, causing a temporary disconnection between the CTC
computer and the node.
Step 1 Click the Provisioning > Security > Data Comm tabs.
Step 2 Click Change Mode.
Step 3 Review the information on the Change Secure Mode wizard page, then click Next.
Step 4 On the Node IP Address page, choose the address you want to assign to the node:
• MIC C/T/P Ethernet Port—Assigns the MIC-C/T/P IP address as the node IP address.
• TCC Ethernet Port—Assigns the TCC2P port IP address as the node IP address
• New IP Address—Allows you to define a new IP address. If you choose this option, enter the new
IP address, subnet mask, and default router IP address.
Step 5 Click Next.
Purpose This task disables the ONS 15454 SDH security mode and allows only one
IP address to be provisioned for the MIC-C/T/P LAN port and the TCC2P
LAN port.
Tools/Equipment TCC2P cards must be installed.
Prerequisite Procedures NTP-D108 Back Up the Database, page 15-5
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
