EasyManua.ls Logo

Cisco ONS 15454 SDH - DLP- D67 Provision the IIOP Listener Port on the ONS 15454 SDH

Cisco ONS 15454 SDH
860 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
17-57
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D67 Provision the IIOP Listener Port on the ONS 15454 SDH
DLP-D67 Provision the IIOP Listener Port on the ONS 15454 SDH
Note If the Enable Proxy Server on port 1080 check box is checked, CTC will use port 1080 and ignore the
configured IIOP port setting. If Enable Proxy Server is subsequently unchecked, the configured IIOP
listener port will be used.
Step 1 In node view, click the Provisioning > Network > General tabs.
Step 2 In the TCC CORBA (IIOP) Listener Port area, choose a listener port option:
Default - TCC Fixed—Uses Port 57790 to connect to ONS 15454 SDH nodes on the same side of
the firewall or if no firewall is used (default). This option can be used for access through a firewall
if Port 57790 is open.
Standard Constant—Uses Port 683, the CORBA default port number.
Other Constant—If Port 683 is not used, type the IIOP port specified by your firewall
administrator.
Step 3 Click Apply.
Step 4 When the Change Network Configuration message appears, click Yes .
Both TCC2/TCC2P cards reboot, one at a time. The reboot takes approximately 15 minutes. See
Table 19-4 on page 19-55.
Step 5 Return to your originating procedure (NTP).
DLP-D68 Provision the IIOP Listener Port on the CTC Computer
Step 1 In node view, from the Edit menu, choose Preferences.
Purpose This task sets the Internet Inter-ORB Protocol (IIOP) listener port on the
ONS 15454 SDH, which enables you to access ONS 15454 SDH nodes
that reside behind a firewall.
Tools/Equipment IIOP listener port number provided by your LAN or firewall administrator
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task selects the IIOP listener port on CTC.
Tools/Equipment IIOP listener port number from LAN or firewall administrator.
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed. Required if the computer running CTC resides behind a
firewall.
Onsite/Remote Onsite or remote
Security Level Provisioning or higher

Table of Contents

Other manuals for Cisco ONS 15454 SDH

Related product manuals