Cisco ONS 15454 SDH - Figure 18-7 Enabling or Disabling Pointer Justification Count Parameters; Table 18-3 Traffic Cards that Terminate the Line (Ltes)

18-20
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D121 Enable Pointer Justification Count Performance Monitoring
Step 3 Click the Provisioning > Line tabs.
Step 4 Click the PJVC4Mon# drop-down list and make a selection based on the following rules (Figure 18-7):
• Off means pointer justification monitoring is disabled (default).
• Val u e s 1 t o n are the number of VC4s on the port. One VC4 per port can be enabled from the
PJVC4Mon# card drop-down list.
Figure 18-7 Enabling or Disabling Pointer Justification Count Parameters
Step 5
In the Service State field, confirm that the port is in the Unlocked-enabled service state.
Step 6 If the port is Unlocked-enabled, click Apply. If the port is out of service (Locked-enabled,disabled;
Locked-enabled,maintenance; Unlocked-disabled,automaticInService), choose Unlocked in the Admin
State drop-down list and click Apply.
OC192 SR/STM64 IO 1310
OC192 IR/STM64 SH 1550
OC192 LR/STM64 LH 1550
OC192 ELR/STM64 LH ITU 15xx.xx
Ta b l e 1 8 - 3 Tr a f f i c C a r d s t h a t Te rm i n ate the Line (LTEs) (continued)
Line Terminating Equipment
Provisioning tabLine tab Card view PJVC4Mon#
102019