Cisco ONS 15454 SDH - Threshold Options for the STM1 E-12 Card

20-53
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D342 Change Line and Threshold Settings for the STM1E-12 Card
Table 20-24 describes the values on the Provisioning > SDH Thresholds tab for the STM1E-12 cards.
Table 20-25 describes the values on the Provisioning > VC4 tab for the STM1E-12 cards.
Step 8 Return to your originating procedure (NTP).
Table 20-24 Threshold Options for the STM1E-12 Card
Parameter Description
Port (Display only) Port number; 1 to 12.
ES Errored seconds.
SES Severely errored seconds.
BBE Background block errors.
UAS Unavailable seconds.
EB Errored blocks.
15 Min radio button Clicking this radio button and then clicking Refresh will cause the threshold
values on this tab to display for 15-minute intervals.
1 Day radio button Clicking this radio button and then clicking Refresh will cause the threshold
values on this tab to display for 1-day intervals.
Table 20-25 VC4 Options for the STM1E-12 Card
Parameter Description Options
VC4 # (Display only) VC4 container number. 1 to 12
Enable IPPM Sets intermediate path performance monitoring (IPPM).
Note To provision IPPM, circuits must be provisioned
on the STM1E-12 card. For circuit creation
procedures, go to Chapter 6, “Create Circuits
and Low-Order Tunnels.” To provision IPPM,
go to the “DLP-D121 Enable Pointer
Justification Count Performance Monitoring”
task on page 18-19.
—
SF Ber Level Sets the signal fail bit error rate for the configured VC12
or VC4 circuit.
• 1E-3
• 1E-4
• 1E-5
SD Ber Level Sets the signal degrade bit error rate for the configured
VC12 or VC4 circuit.
• 1E-5
• 1E-6
• 1E-7
• 1E-8
• 1E-9