Cisco ONS 15454 SDH - DLP- D460 View FC_MR-4 Statistics PM Parameters

21-37
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D460 View FC_MR-4 Statistics PM Parameters
DLP-D460 View FC_MR-4 Statistics PM Parameters
Step 1 In node view, double-click the FC_MR-4 card where you want to view PM counts. The card view
appears.
Step 2 Click the Performance > Statistics tabs (Figure 21-11).
Figure 21-11 FC_MR-4 Statistics in the Card View Performance Window
Step 3
Click Refresh. Performance monitoring statistics for each port on the card appear.
Step 4 View the PM parameter names that appear in the Param column. The current PM parameter values appear
in the port number columns. For PM parameter definitions, refer to the “Performance Monitoring”
chapter in the Cisco ONS 15454 SDH Reference Manual.
Step 5 Return to your originating procedure (NTP).
Purpose This task enables you to view current statistical PM counts on an
FC_MR-4 card and port to detect possible performance problems.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher
124915
Performance
tab
Card View
Statistics
tab
Clear
button
Baseline
button
Auto-refresh
drop-down list
Refresh
button