Cisco ONS 15454 SDH - Figure 21-7 Alarm Filter Dialog Box Conditions Tab

21-14
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D428 Modify Alarm, Condition, and History Filtering Parameters
Figure 21-7 Alarm Filter Dialog Box Conditions Tab
When filtering is enabled, conditions in the Show list are visible and conditions in the Hide list are
invisible.
• To move conditions individually from the Show list to the Hide list, click the > button.
• To move conditions individually from the Hide list to the Show list, click the < button.
• To move conditions collectively from the Show list to the Hide list, click the >> button.
• To move conditions collectively from the Hide list to the Show list, click the << button.
Note Conditions include alarms.
Step 6 Click Apply and OK.
Alarm and condition filtering parameters are enforced when alarm filtering is enabled (see the
“DLP-D225 Enable Alarm Filtering” task on page 19-24), and are not enforced when alarm filtering is
disabled (see the “DLP-D227 Disable Alarm Filtering” task on page 19-25).
Step 7 Return to your originating procedure (NTP).