21-25
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D436 Delete Ethernet RMON Alarm Thresholds
DLP-D436 Delete Ethernet RMON Alarm Thresholds
Note The ONS 15454 SDH ML-Series cards use the Cisco IOS command line interface (CLI) for managing
RMON.
Step 1 Double-click the Ethernet card where you want to delete the RMON alarm thresholds.
Step 2 In card view, click the Provisioning > RMON Thresholds tabs.
Step 3 Click the RMON alarm threshold you want to delete.
Step 4 Click Delete. The Delete Threshold dialog box appears.
Step 5 Click Ye s to delete that threshold.
Step 6 Return to your originating procedure (NTP).
DLP-D437 Change Node Access and PM Clearing Privilege
Step 1 In node view, click the Provisioning > Security > Access tabs.
Step 2 In the Access area, provision the following:
• LAN access—Choose one of the following options to set the access paths to the node:
–
No LAN Access—Allows access to the node only through data communications channel (DCC)
connections. Access through the TCC2/TCC2P RJ-45 port and backplane is not permitted.
–
Front only—Allows access through the TCC2/TCC2P RJ-45 port. Access through the DCC and
the backplane is not permitted.
Purpose This task deletes remote monitoring (RMON) threshold crossing alarms
for Ethernet ports.
Tools/Equipment None
Prerequisite Procedures DLP-D441 Create Ethernet RMON Alarm Thresholds, page 21-28
DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Purpose This task provisions the physical access points and shell programs used to
connect to the ONS 15454 SDH and sets the user security level that can
clear node performance monitoring data.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Superuser
To Next Page
Loading...
