Cisco ONS 15454 SDH - Figure 5-7 SNCP DRI Fiber Connection Example; NTP- D217 Provision a Traditional SNCP Dual-Ring Interconnect

5-27
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 5 Turn Up a Network
NTP- D217 Provision a Traditional SNCP Dual-Ring Interconnect
• The interconnect nodes must have fiber connections. An example is shown in Figure 5-7. This
example shows an SNCP DRI with two rings, Nodes 1 to 4 and 5 to 8. In the example, an additional
STM-N is installed in Slot 13 at Node 4 and connected to an STM-N in Slot 6 at Node 6. Nodes 3
and 5 are interconnected with STM-N cards in Slot 6 (Node 3) and Slot 13 (Node 5).
Figure 5-7 SNCP DRI Fiber Connection Example
Stop. You have completed this procedure.
Node 1
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 3
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 2
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 4
Slot 5
Tx
Rx
Slot 12
Tx
Rx
83499
Node 5
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 7
Slot 5
Tx
Rx
Slot 12
Tx
Rx
Node 6
Slot 5
Tx
Rx
Slot 6
Tx
Rx
Slot 13
Tx
Rx
Slot 13
Tx
Rx
Slot 6
Tx
Rx
Slot 12
Tx
Rx
Node 8
Slot 5
Tx
Rx
Slot 12
Tx
Rx