17-24
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 17 DLPs D1 to D99
DLP- D29 Change Tunnel Type
Step 10 Return to your originating procedure (NTP).
DLP-D29 Change Tunnel Type
Step 1 From the View menu, choose Go to Network View.
Step 2 Click the Provisioning > Overhead Circuits tabs.
Step 3 Click the circuit tunnel that you want to convert.
Step 4 Click Edit.
Step 5 In the Edit circuit window, click the Tunnel tab.
Step 6 In the Attributes area, complete the following:
• If you are converting a traditional DCC tunnel to an IP-encapsulated tunnel, check the Change to
IP Tunnel check box and type the percentage of total RS-DCC bandwidth used in the IP tunnel (the
minimum percentage is 10 percent).
• If you are converting an IP tunnel to a traditional DCC tunnel, check the Change to RS-DCC
Tunnel check box.
Step 7 Click Apply.
Step 8 In the confirmation dialog box, click Yes to continue.
Step 9 In the Circuit Changed status box, click OK to acknowledge that the circuit change was successful.
Step 10 Return to your originating procedure (NTP).
Purpose This task converts a traditional DCC tunnel to an IP-encapsulated tunnel or
an IP-encapsulated tunnel to a traditional RS-DCC tunnel.
Tools/Equipment None
Prerequisite Procedures DLP-D361 Create a DCC Tunnel, page 20-66
DLP-D4 Create an IP-Encapsulated Tunnel, page 17-3
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
To Next Page
Loading...
