Cisco ONS 15454 SDH - VC4 Tab for Enabling or Disabling IPPM

18-22
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 18 DLPs D100 to D199
DLP- D122 Enable Intermediate Path Performance Monitoring
Figure 18-8 VC4 Tab for Enabling or Disabling IPPM
Step 3
Click the check box in the Enable IPPM column and make a selection based on the following rules:
• Unchecked means that IPPM is disabled for that VC4 (default).
• Checked means that IPPM is enabled for that VC4.
Step 4 Click Apply.
Step 5 Click the Performance tab to view PM parameters. For IPPM parameter definitions, refer to the
“Performance Monitoring” chapter in the Cisco ONS 15454 SDH Reference Manual.
Step 6 Return to your originating procedure (NTP).
VC4 tab Provisioning tab Card view Apply button
102009