Cisco ONS 15454 SDH - DLP- D433 Run the CTC Installation Wizard for Windows

21-18
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D433 Run the CTC Installation Wizard for Windows
Figure 21-8 Port Status on the LCD Panel
Step 4
Return to your originating procedure (NTP).
DLP-D433 Run the CTC Installation Wizard for Windows
Note If you will log into nodes running CTC software earlier than R4.6, uninstall JRE 1.4.2 or 5.0 and reinstall
JRE 1.3.1_2. To run Software R7.0, uninstall JRE 1.3.1_2 and reinstall JRE 1.4.2 or 5.0. Software R7.0
supports JRE 1.4.2 or JRE 5.0; JRE 1.4.2 is provided on the software CD.
Note JRE 1.4.2 requires Netscape 7.x or Internet Explorer 6.x.
Step 1 Verify that your computer has the following:
• Processor—Pentium III, 700 Mhz or faster
• RAM—384 MB recommended, 512 MB optimum
• Hard drive—20 GB hard drive recommended with at least 50 MB of space available
• Operating system—Windows 98 (1st and 2nd editions), Windows NT 4.0 (with Service Pack 6a),
Windows 2000 (with Service Pack 3), or Windows XP Home
Purpose This task installs the CTC online user manuals, Acrobat Reader 6.0.1, Java
Runtime Environment (JRE) 1.4.2, and the CTC Java Archive (JAR) files.
JRE 1.4.2 is required to run Software Release 7.0. Preinstalling the CTC
JAR files saves time at initial login. If the JAR files are not installed, they
are downloaded from the TCC2/TCC2P card the first time you log in.
Tools/Equipment Cisco ONS 15454 SDH Release 7.0 software CD
Prerequisite Procedures None
Required/As Needed This task is required if any one of the following is true:
• JRE 1.4.2 or 5.0 is not installed.
• CTC online user manuals are not installed and are needed.
• CTC JAR files are not installed and are needed.
Onsite/Remote Onsite or remote
Security Level None
FAN FAIL
Slot
Slot 13
Working / Active
Port 1
102029
CRIT MAJ MIN
Status Port