21-19
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 21 DLPs D400 to D499
DLP- D433 Run the CTC Installation Wizard for Windows
If your operating system is Windows NT 4.0, verify that Service Pack 6a or later is installed. From
the Start menu, choose Programs > Administrative Tools > Windows NT Diagnostics and check
the service pack on the Version tab of the Windows NT Diagnostics dialog box. If Service Pack 6a
or later is not installed, do not continue. Install Service Pack 6a following the computer upgrade
procedures for your site.
Note Processor and RAM requirements are guidelines. CTC performance is faster if your computer
has a faster processor and more RAM.
Step 2 Insert the Cisco ONS 15454 SDH Release 7.0 software CD into your computer CD drive. The
installation program begins running automatically. If it does not start, navigate to your computer’s CD
directory and double-click setup.exe.
The Cisco Transport Controller Installation wizard displays the components that will be installed on
your computer:
• JRE 1.4.2
• Acrobat Reader 6.0.1
• Online User Manuals
• CTC JAR files
Step 3 Click Next.
Step 4 Complete one of the following:
• Click Typical to install both the Java Runtime Environment and the online user manuals.
• Click Custom if you want to install either the JRE or the online user manuals.
Step 5 Click Next.
Step 6 Complete the following, as applicable:
• If you selected Typical in Step 4, skip this step and proceed to Step 7.
• If you selected Custom, select the CTC component that you want to install and click Next.
–
If you selected Online User Manuals, continue with Step 7.
–
If you did not select Online User Manuals, continue with Step 9.
Step 7 The directory where the installation wizard will install the CTC online user manuals appears. The default
is C:\Program Files\Cisco\CTC\Documentation.
• If you want to change the CTC online user manuals directory, type the new directory path in the
Directory Name field, or click Browse to navigate to the directory.
• If you do not want to change the directory, skip this step.
Step 8 Click Next.
Step 9 Review the components that will be installed. If you want to change your selections:
• If you selected Typical in Step 4, click Back twice to return to the installation setup type page.
Choose Custom and repeat Steps 5 through 8.
• If you selected Custom in Step 4, click Back once or twice (depending on the components selected)
until the component selection page appears. Repeat Steps 6 through 8.
Step 10 Click Next. It might take a few minutes for the JRE installation wizard to appear. If you selected Custom
in Step 4 and need to install a JRE, continue with Step 12.
To Next Page
Loading...
