Cisco ONS 15454 SDH - DLP- D356 Change Enhanced FC;FICON Port Settings for the FC_MR-4 Card

20-63
Cisco ONS 15454 SDH Procedure Guide, R7.0
78-17194-01
Chapter 20 DLPs D300 to D399
DLP- D356 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card
DLP-D356 Change Enhanced FC/FICON Port Settings for the FC_MR-4 Card
Note For the default values and domains of user-provisionable card settings, refer to the “Network Element
Defaults” appendix in the Cisco ONS 15454 SDH Reference Manual.
Step 1 In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 2 Click the Provisioning > Port > Enhanced FC/FICON tabs.
Step 3 Modify any of the settings described in Table 20-29 by clicking in the field you want to modify. In some
fields you can choose an option from a drop-down list; in others you can type a value or select or deselect
a check box.
Step 4 Click Apply.
Step 5 Return to your originating procedure (NTP).
Purpose This task changes the enhanced FC/FICON parameters for FC_MR-4
ports.
Tools/Equipment None
Prerequisite Procedures DLP-D60 Log into CTC, page 17-49
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher
Table 20-29 FC_MR-4 Card Distance Extension Port Settings
Parameter Description Options
Port (Display only) The card port number. 1 through 4
Ingress Idle
Filtering
If checked, prevents removal of excess Fibre
Channel/FICON IDLE codes from SONET
transport. IDLEs are 8b10b control words that are
sent between frames when there is no data to send.
Ingress idle filtering applies only to SONET circuit
bandwidth sizes that allow full line rate Fibre
Channel/FICON transport. It can be used for
interoperability with remote Fibre Channel/FICON
over third-party SONET equipment.
—
Maximum
Frame Size
Sets the maximum size of a valid frame. This setting
prevents oversized performance monitoring
accumulation for frame sizes that are above the Fibre
Channel maximum. This can occur for
Fibre Channel frames with added virtual SAN
(VSAN) tags that are generated by the
Cisco MDS 9000 switches.
Numeric. 2148 through 2172